Before You Begin; Endpoint Setup - Polycom ReadiManagerLX100 Management Manual

Before You Begin

Endpoint setup

V-Series
Make sure the unit is connected to the LAN and is turned on. V-Series will auto detect LAN properties and provide
guidance in setting up this feature.
ViewStation Support
For ReadiManager LX100 to fully support management and monitoring of the ViewStation, you must update
ViewStations software to at least Version 7.5, otherwise Polycom ReadiManager LX100 cannot provide the system
status information for ViewStations that are not yet updated.
For instructions on connecting your ViewStations to your LAN please refer to page 114.
ViaVideo Support
Install the latest ViaVideo software version (5.1 or greater). Updating the ViaVideo software cannot be done through
the Software Update feature. This must be done manually from each PC unit.
Make sure the PC is connected to the LAN.
For iPower Support:
Install the latest iPower software version (5.5 or greater). Please refer to page 115 for instructions on enabling
ReadiManager LX100 support on iPower.
For SoundStation VTX 1000 Support:
•
•
•
Polycom ReadiManager LX100 User Guide
Upgrade SoundStation VTX 1000 Software to release 1.30 or later.
NOTE
If a SoundStation VTX 1000 has code that is older than version 1.30 (1.29 or earlier), the phone must be manually
updated to version 1.30 through the SoundStation VTX 1000 user interface (see Administrator's Guide) before the
ReadiManager LX100 can provide remote software support.
Install at least 1 Rapidport multi-port modem on the ReadiManager LX100 server. Upon installation of
the modem with the installation CD provided, be sure that the very latest modem drivers are installed by
downloading them from -
http://www.ionetworks.com/support/epdrivers.jsp#E2K
Install the software on a computer that meets the minimum system requirements ; SoundStation VTX 1000
support is provided in ReadiManager LX100 software releases 6.10 and later.
Chapter 1 Getting Started 3