Snmp Configuration - Polycom ReadiManagerLX100 Management Manual

Remote Alert Notification
SNMP Configuration
The table above shows what type of messages are sent for each device.
Adding a SNMP alert
1. Click on Add, a new window will pop up.
2. Name the Alert. The Alert Name can be a person's name.
3. Choose the Alert type from the pull down menu: SNMP
4. Click on Enable SNMP Remote Alert Notification. This must be checked for SNMP traps to be sent out to the
5. Click on the check boxes to specify which SNMP traps are to be sent for each device type.
6. Specify how many minutes apart each SNMP trap should be issued from Remote Alerts.
7. Click on the Save Settings button to ensure the settings are saved.
For the definitions of the MIB, please refer to the appendix section of this User Guide.
For instructions on how to send SNMP traps from the Polycom ReadiManager LX100 server, please refer to the
"Sending SNMP traps" document in the documents folder.
Polycom ReadiManager LX100 User Guide
Figure 8.4 Configuration > Remote Alert Notification > Add SNMP Alert
SNMP manager.
For more information on the notification configuration, please refer to the next page.
Enter the Alert
Name. This is used
to identify the
Alert.
This box must be
checked for SNMP
notification to be
enabled
Check off which
error messages
you want to
receive for each
device type
Indicate how
often you want
to receive error
messages
Chapter 8 System Configuration 88