Polycom ReadiManagerLX100 Management Manual page 25

Other System Management Functions
Manage System
Polycom Video Endpoints
Polycom video endpoints have an embedded web server that allows you to manage the unit from a remote PC on the
same local area network. Any endpoint can be managed by calling up it's IP address in any web browser. To remotely
manage a system through Polycom ReadiManager LX100, select the system of interest in the system list and then
click on the Manage System button. A new browser window will appear displaying the endpoint's web page.
Remote Management allows you to:
•
•
•
Certain video endpoint models require specific setups in order to access the web interface. See below.
ViaVideo
For versions below 5.0:
To manage ViaVideo, the "Web Access Password" must be set through ViaVideo. If the "Web Access Password" is not
configured, ReadiManager LX100 cannot access the web interface of ViaVideo.
To set the web access password from the ViaVideo interface, go to:
System Information > Setup > Global Services > Global Management
Enter the "Web Access Password".
For 5.0 and above
To set the web access password from the ViaVideo interface, go to:
Setup > Web/GMS >
Enter the "Admin Password".
iPower
iPower like the ViewStation also has an embedded web server that allows remote administration. Manage System
launches iPower WebRemote. WebRemote lets you make calls, configure the system, diagnose operating problems,
and monitor system performance from a web browser running on a remote PC. In order to use WebRemote, it must be
enabled on the system.
Polycom ReadiManager LX100 User Guide
Run diagnostic tests on a system
Change the system configuration for the endpoint
Place a call from the system for line status verification
Chapter 2 System Management 18