Mac-Based Vlan Commands; Display Mac-Vlan - H3C S6812 Series Command Reference Manual

To enable a trunk port to transmit packets from its PVID, you must assign the trunk port to the PVID
by using the port trunk permit vlan command.
Examples
# Configure Ten-GigabitEthernet 1/0/1 as a trunk, set its PVID to VLAN 100, and assign it to VLAN
100.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port link-type trunk
[Sysname-Ten-GigabitEthernet1/0/1] port trunk pvid vlan 100
[Sysname-Ten-GigabitEthernet1/0/1] port trunk permit vlan 100
Related commands
port link-type
port trunk permit vlan

MAC-based VLAN commands

display mac-vlan

Use display mac-vlan to display MAC-to-VLAN entries.
Syntax
display mac-vlan { all | dynamic | mac-address mac-address [ mask mac-mask ] | static | vlan
vlan-id }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
all: Specifies all MAC-to-VLAN entries.
dynamic: Specifies dynamically configured MAC-to-VLAN entries.
mac-address mac-address: Specifies the MAC address in the MAC-to-VLAN entry. The format of
the mac-address argument is H-H-H.
mask mac-mask: Specifies the mask for matching MAC addresses in MAC-to-VLAN entries. For the
mac-mask argument, the high-order bits must be consecutive 1s in binary notation or consecutive Fs
in hexadecimal notation. The default value is ffff-ffff-ffff.
static: Specifies statically configured MAC-to-VLAN entries.
vlan vlan-id: Specifies the VLAN in MAC-to-VLAN entries. The value range for the vlan-id argument
is 1 to 4094.
Examples
# Display all MAC-to-VLAN entries.
<Sysname> display mac-vlan all
The following MAC VLAN entries exist:
State: S - Static, D - Dynamic
18