Qinq Ethernet-Type (System View) - H3C S6812 Series Command Reference Manual

hex-value: Sets a hexadecimal TPID value in the range of 1 to ffff, excluding the reserved EtherType
values listed in
Table 1 Reserved EtherType values
Protocol type
ARP
PUP
RARP
IP
IPv6
PPPoE
MPLS
IPX/SPX
IS-IS
LACP
LLDP
802.1X
802.1ag
Cluster
Reserved
Usage guidelines
A service provider-side port uses the SVLAN TPID to replace the TPID in outgoing frames' SVLAN
tags and match incoming tagged frames. An incoming frame is handled as untagged if the TPID in its
outer VLAN tag is different from the SVLAN TPID.
Examples
# Set the TPID value in SVLAN tags to 9100 (hexadecimal) on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qinq ethernet-type service-tag 9100
Related commands

qinq ethernet-type (system view)

qinq ethernet-type (system view)
Use qinq ethernet-type to set the TPID value in CVLAN tags.
Use undo qinq ethernet-type to restore the default TPID value in CVLAN tags.
Syntax
qinq ethernet-type customer-tag hex-value
undo qinq ethernet-type customer-tag
Default
The TPID value in CVLAN tags is 8100 in hexadecimal notation.
Table 1.
Value
0x0806
0x0200
0x8035
0x0800
0x86dd
0x8863/0x8864
0x8847/0x8848
0x8137
0x8000
0x8809
0x88cc
0x888e
0x8902
0x88a7
0xfffd/0xfffe/0xffff
3