H3C S6812 Series Command Reference Manual page 294

irf-port2 interface-list2: Specifies a space-separated list of up to four interface items. Each interface
item specifies one interface in the interface-type interface-number form. The interfaces are bound to
IRF-port 2. A physical interface can be bound only to one IRF port.
Usage guidelines
This command bulk-configures basic IRF settings for a member device, including the member ID,
domain ID, priority, and IRF port bindings.
The easy IRF feature provides the following configuration methods:
•
Interactive method—Enter the easy-irf command without parameters. The system will guide
you to set the parameters step by step.
•
Non-interactive method—Enter the easy-irf command with parameters.
As a best practice, use the interactive method if you are new to IRF.
If you execute this command multiple times, the following settings take effect:
•
The most recent settings for the member ID, domain ID, and priority.
•
IRF port bindings added through executions of the command. You can bind a maximum of four
physical interfaces to an IRF port.
When you specify physical interfaces for an IRF port, you must follow the IRF port binding
requirements in IRF Configuration Guide.
If you specify physical interfaces by using the interactive method, you must also follow these
restrictions and guidelines:
•
Do not enter spaces between the interface type and interface number.
•
Use a comma (,) to separate two physical interfaces. No spaces are allowed between
interfaces.
To remove an IRF physical interface from an IRF port, you must use the undo port group interface
command in IRF port view.
Examples
# Bulk-configure basic IRF settings by using the non-interactive method. Change the member ID
from 2 to 3, set the domain ID to 10, configure the member priority as 10, and bind
Ten-GigabitEthernet 2/0/1 through Ten-GigabitEthernet 2/0/4 to IRF-port 1.
<Sysname> system-view
[Sysname] easy-irf member 2 renumber 3 domain 10 priority 10 irf-port1 ten-gigabitethernet
2/0/1 ten-gigabitethernet 2/0/2 ten-gigabitethernet 2/0/3 ten-gigabitethernet 2/0/4
*****************************************************************************
IRF new member ID: 3
IRF domain ID
IRF priority
IRF-port 1
IRF-port 2
*****************************************************************************
Are you sure to use these settings to set up IRF? [Y/N] y
Starting to configure IRF...
Configuration succeeded.
The device will reboot for the new member ID to take effect. Continue? [Y/N] y
# Bulk-configure basic IRF settings by using the interactive method. Change the member ID from 3
to 5, set the domain ID to 10, configure the member priority as 10, and bind Ten-GigabitEthernet
3/0/1 through Ten-GigabitEthernet 3/0/4 to IRF-port 1.
Configuration summary for member 2
: 10
: 10
: Ten-GigabitEthernet2/0/1, Ten-GigabitEthernet2/0/2
Ten-GigabitEthernet2/0/3, Ten-GigabitEthernet2/0/4
: Disabled
10