Configuration Commit - H3C S6812 Series Command Reference Manual

Predefined user roles
network-admin
Parameters
ipv4-server: Specifies a TFTP server by its IPv4 address or host name. The host name is a
case-insensitive string of 1 to 253 characters. Valid characters include letters, digits, hyphens (-),
underscores (_), and dots (.).
ipv6 ipv6-server: Specifies a TFTP server by its IPv6 address or host name. The host name is a
case-insensitive string of 1 to 253 characters. Valid characters include letters, digits, hyphens (-),
underscores (_), and dots (.).
dest-filename: Specifies the name of the target file used for saving the file on the server. The file
name must use the .cfg extension. Excluding the .cfg extension, the file name is a case-insensitive
string of 1 to 255 characters. If you do not specify a target file name, the source file name is used.
Usage guidelines
This command is not supported in FIPS mode.
Examples
# Back up the main next-startup configuration file to the IPv4 TFTP server at 2.2.2.2, and set the
target file name to 192-168-1-26.cfg.
<Sysname> backup startup-configuration to 2.2.2.2 192-168-1-26.cfg
Backing up the main startup configuration file to 2.2.2.2...
Done.
# Back up the main next-startup configuration file to the IPv6 TFTP server at 2001::2, and set the
target file name to 192-168-1-26.cfg.
<Sysname> backup startup-configuration to ipv6 2001::2 192-168-1-26.cfg
Backing up the main startup configuration file to 2001::2...
Done.
Related commands
restore startup-configuration

configuration commit

Use configuration commit to commit the settings configured after the configuration commit
delay command was executed.
Syntax
configuration commit
Views
System view
Predefined user roles
network-admin
Usage guidelines
You must execute the configuration commit delay command before executing this command.
As a best practice, enable the information center and configure the information center to output logs
to the console. Determine whether to commit the settings depending on the logs. For more
information about the information center, see Network Management and Monitoring Configuration
Guide.
5