Port Trunk Pvid - H3C S6812 Series Command Reference Manual

Predefined user roles
network-admin
Parameters
vlan-id-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN ID
or a range of VLAN IDs in the form of vlan-id1 to vlan-id2. The value range for VLAN IDs is 1 to 4094.
The value for the vlan-id2 argument must be equal to or greater than the value for the vlan-id1
argument.
all: Specifies all VLANs. To prevent unauthorized VLAN users from accessing restricted resources
through the port, use the port trunk permit vlan all command with caution.
Usage guidelines
A trunk port can allow multiple VLANs. If you execute this command multiple times on a trunk port,
the trunk port allows all the specified VLANs.
On a trunk port, packets only from the PVID can pass through untagged.
Examples
# Configure Ten-GigabitEthernet 1/0/1 as a trunk port, and assign it to VLAN 2, VLAN 4, and VLAN
50 through VLAN 100.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port link-type trunk
[Sysname-Ten-GigabitEthernet1/0/1] port trunk permit vlan 2 4 50 to 100
Related commands
port link-type

port trunk pvid

Use port trunk pvid to set the PVID for a trunk port.
Use undo port trunk pvid to restore the default.
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
Default
The PVID of a trunk port is VLAN 1.
Views
Layer 2 aggregate interface view
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
vlan-id: Specifies a VLAN by its ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a trunk port. When you delete the PVID of a trunk
port by using the undo vlan command, the PVID setting of the port does not change.
For correct packet transmission, set the same PVID for a local trunk port and its peer.
17