Passive - H3C S6812 Series Command Reference Manual

Syntax
open server-address [ service-port ]
Views
FTP client view
Predefined user roles
network-admin
Parameters
server-address: Specifies the IPv4 address, IPv6 address, or host name of the FTP server.
service-port: Specifies the TCP port number of the FTP server, in the range of 0 to 65535. The
default is 21.
Usage guidelines
After you issue this command, the system will prompt you to enter the username and password.
After you log in to one FTP server, you must disconnect from the server before you can use the open
command to log in to another server.
Examples
# In FTP client view, log in to FTP server 192.168.40.7.
<Sysname>ftp
ftp> open 192.168.40.7
Press CTRL+C to abort.
Connected to 192.168.40.7 (192.168.40.7).
220 FTP service ready.
User (192.168.40.7:(none)): root
331 Password required for root.
Password:
230 User logged in.
Remote system type is H3C.
ftp>

passive

Use passive to change the FTP operation mode.
Syntax
passive
Default
The FTP operation mode is passive.
Views
FTP client view
Predefined user roles
network-admin
Usage guidelines
FTP can operate in either of the following modes:
•
Active mode—The FTP server initiates the TCP connection.
24