Stp Vlan Enable - H3C S6812 Series Command Reference Manual

If this command is configured in Layer 2 aggregate interface view, it takes effect only on the
aggregate interface.
If this command is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# Set the BPDU transmission rate of Ten-GigabitEthernet 1/0/1 to 5.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] stp transmit-limit 5

stp vlan enable

Use stp vlan enable to enable the spanning tree feature for VLANs.
Use undo stp enable to disable the spanning tree feature for VLANs.
Syntax
stp vlan vlan-id-list enable
undo stp vlan vlan-id-list enable
Default
The spanning tree feature is enabled in VLANs.
Views
System view
Predefined user roles
network-admin
Parameters
vlan vlan-id-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a
VLAN or a range of VLANs in the form of vlan-id1 [ to vlan-id2 ]. The value for vlan-id2 must be equal
to or greater than the value for vlan-id1. The value range for the vlan-id argument is 1 to 4094. If you
do not specify this option, this command globally enables or disables the spanning tree feature
(VLANs are not included).
Usage guidelines
When you enable the spanning tree feature, the device operates in STP, RSTP, PVST, or MSTP
mode, depending on the spanning tree mode setting.
When you enable the spanning tree feature, the device dynamically maintains the spanning tree
status of VLANs, based on received configuration BPDUs. When you disable the spanning tree
feature, the device stops maintaining the spanning tree status.
Examples
# In PVST mode, globally enable the spanning tree feature and then enable the spanning tree
feature for VLAN 2.
<Sysname> system-view
[Sysname] stp mode pvst
[Sysname] stp global enable
[Sysname] stp vlan 2 enable
Related commands
stp enable
52