Terminal Type - H3C S6812 Series Command Reference Manual

Views
System view
Predefined user roles
network-admin
Parameters
dscp-value: Specifies a DSCP value in the range of 0 to 63.
Usage guidelines
This command is not supported in FIPS mode.
The DSCP value is carried in the Traffic class field of an IPv6 packet to indicate the packet
transmission priority.
Examples
# Set the DSCP value for IPv6 to use for outgoing Telnet packets to 30 on a Telnet server.
<Sysname> system-view
[Sysname] telnet server ipv6 dscp 30

terminal type

Use terminal type to specify the terminal display type.
Use undo terminal type to restore the default.
Syntax
terminal type { ansi | vt100 }
undo terminal type
Default
The terminal display type is ANSI.
Views
User line view
User line class view
Predefined user roles
network-admin
Parameters
ansi: Specifies the ANSI type.
vt100: Specifies the VT100 type.
Usage guidelines
The device supports two terminal display types: ANSI and VT100. As a best practice, specify the
VT100 type on both the device and the configuration terminal. If either side uses the ANSI type, a
display problem might occur when a command line has more than 80 characters. For example, a
cursor positioning error might occur.
This command is available in both user line view and user line class view. A non-default setting in
either view takes precedence over a default setting in the other view. A non-default setting in user
line view takes precedence over a non-default setting in user line class view.
A terminal display type change does not take effect for the current session. It takes effect for
subsequent login sessions.
45