Lldp Timer Tx-Interval; Lldp Tlv-Enable - H3C S6812 Series Command Reference Manual

Views
System view
Predefined user roles
network-admin
Parameters
delay: Sets the LLDP reinitialization delay in the range of 1 to 10 seconds.
Examples
# Set the LLDP reinitialization delay to 4 seconds.
<Sysname> system-view
[Sysname] lldp timer reinit-delay 4

lldp timer tx-interval

Use lldp timer tx-interval to set the LLDP frame transmission interval.
Use undo lldp timer tx-interval to restore the default.
Syntax
lldp timer tx-interval interval
undo lldp timer tx-interval
Default
The LLDP frame transmission interval is 30 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
interval: Sets the LLDP frame transmission interval in the range of 5 to 32768 seconds.
Examples
# Set the LLDP frame transmission interval to 20 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-interval 20

lldp tlv-enable

Use lldp tlv-enable to configure the types of advertisable TLVs on a port.
Use undo lldp tlv-enable to disable the advertising of the specified types of TLVs on a port.
Syntax
In Layer 2 Ethernet interface view:
•
For nearest bridge agents:
lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name | management-address-tlv [ ipv6 ] [ ip-address ] } | dot1-tlv { all | port-vlan-id
| link-aggregation | protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] | management-vid
[ mvlan-id ] } | dot3-tlv { all | mac-physic | max-frame-size | power } | med-tlv { all | capability
33