Advertisement
and Thermal Options > Thermal Configuration.
b. Select Increased Cooling
Increased Cooling.
c. Save your setting.
d. Reboot the server. A reboot is required after the setting is saved.
2. To enable the increased cooling function in the iLO web interface:
a. From the iLO web interface, select Power & Thermal > Fans.
b. Click
next to the Summary category.
The Fan Settings page opens.
c. Select Increased Cooling
Increased Cooling.
d. Click OK
OK.
Optical drive option
Optical drive option
Install a slim-type SATA optical drive to read/write data on optical discs.
Subtopics
Subtopics
Installing an optical drive
Installing an optical drive
Installing an optical drive
Installing an optical drive
Prerequisites
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Optical drive SATA-power cable option kit (P56688-B21)
T-15 Torx screwdriver
Phillips No. 1 screwdriver
Spudger or any small prying tool
About this task
About this task
Install an optical drive in the optical drive bay.
CAUTION:
CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated
CAUTION:
with either a component or a blank.
Procedure
Procedure
1. Remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
HPE ProLiant ML350 Gen11 Server User Guide
95
Advertisement
