Advertisement
About this task
About this task
When installing a type-o storage controller, install it in Slot 14.
CAUTION:
CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:
CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the
server when a port blank is removed without the corresponding I/O port option installed.
Procedure
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
6. Remove the primary riser cage.
7. Install the type-o storage controller:
a. Rotate the locking pin to the open (vertical) position (callout 1).
b. Slide the controller into the bay until it clicks into place (callout 2).
Make sure that the controller is seated firmly in the slot.
c. Rotate the locking pin to the close (horizontal) position (callout 3).
8. Cable the type-o storage controller .
9. Install the primary riser cage.
HPE ProLiant ML350 Gen11 Server User Guide
113
Advertisement
