HPE ProLiant ML350 Gen11 User Manual page 55

b. Lift the riser cage off the system board (callout 3).
Remove the HPE Remove the HPE NS204i Boot Device NS204i Boot Device
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
6. Remove the boot device from the top of the power supply cage:
a. Pull and hold the latch (callout 1).
b. Remove the boot device from the chassis side wall (callout 2).
HPE ProLiant ML350 Gen11 Server User Guide 55