HPE ProLiant ML350 Gen11 User Manual page 115

Hide thumbs Also See for ProLiant ML350 Gen11:

Before installing the HPE Smart Storage Hybrid Capacitor, verify that the system BIOS meets the minimum firmware requirements to

support the capacitor pack.

IMPORTANT:

If the system BIOS or controller firmware is older than the minimum recommended firmware versions, the capacitor

pack will only support one device.

The capacitor pack is fully charged after the system boots.

Subtopics

Minimum firmware versions

Product

Server system ROM

HPE MR type-o and type-p Gen11 controllers 52.22.3-4650

HPE SR900 series type-p Gen11 controllers

Installing an energy pack

Prerequisites

Make sure that a compatible type-p storage controller is installed .

Make sure that you have the following items availables:

Storage controller backup power cable (ships with the storage controller)

Energy pack extension cable (P58199-B21)

If you are installing the HPE Smart Storage Hybrid Capacitor, verify that the system meets the minimum firmware requirements .

Procedure

1. Power down the server.

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Disconnect all peripheral cables from the server.

4. Do one of the following:

If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .

If the server is in rack mode, remove the server from the rack .

5. Remove the access panel .

6. If installed, remove the HPE NS204i Boot Device .

7. Connect the energy pack extension cable to the energy pack cable.

8. Install the energy pack:

a. Insert the energy pack at an angle (callout 1).

Minimum firmware version

1.20

03.01.14.062

HPE ProLiant ML350 Gen11 Server User Guide

115