Advertisement
8. Install the type-p storage controller:
a. Install the type-p storage contoller (callout 1), and install the screw (callout 2).
Make sure that the controller is seated firmly in the slot.
b. Simultaneously push and rotate to close the riser cage latch (callouts 3 and 4).
9. Install the primary riser cage.
10. Cable the type-p storage controller .
11. To enable the FBWC feature of the storage controller, install an energy pack.
12. Install the access panel
13. Do one of the following:
Orient the server back in tower mode .
Install the server into the rack .
14. Connect all peripheral cables to the server.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server.
18. Before using the controller for the first time, update the server and controller firmware if they are not the latest revision .
Results
Results
The installation is complete.
Installing a type-o storage controller
Installing a type-o storage controller
Prerequisites
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Compatible controller cable
T-10 Torx screwdriver
About this task
About this task
HPE ProLiant ML350 Gen11 Server User Guide
112
Advertisement
