HPE ProLiant ML350 Gen11 User Manual page 123

Hide thumbs Also See for ProLiant ML350 Gen11:

20. Connect each power cord to the server.

21. Connect each power cord to the power source.

22. Power up the server.

Results

The installation is complete.

Processor heatsink assembly option

Subtopics

Processor cautions

Installing the processor heatsink assembly

Processor cautions

CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or

CAUTION:

install the processor in this server.

CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations must

CAUTION:

contain processors with the same part number.

CAUTION: The pins on the processor socket and on the processor are very fragile and easily damaged

CAUTION:

The pins on the processor socket and on the processor are very fragile and easily damaged . To avoid

component damage, do not touch these pins

processor.

IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.

IMPORTANT:

IMPORTANT: If installing a processor with a faster speed, update the system ROM before installing the processor. To

IMPORTANT:

download firmware, go to the Hewlett Packard Enterprise Support Center website ( ).

Installing the processor heatsink assembly

Prerequisites

Before perform this procedure:

Make sure that the compatible fans are installed .

Make sure that you have a T-30 Torx screwdriver available.

About this task

This server supports two heatsink options:

Standard heatsink (P47223-B21)

Performance heatsink (P47224-B21)

Processors with TDP equal to or greater than 195 W require performance heatsinks.

Procedure

1. Power down the server.

2. Remove all power:

do not touch these pins. Any damage to them might require replacing the system board and/or

HPE ProLiant ML350 Gen11 Server User Guide

123