Advertisement
Edition (National Electric Code) and NFPA-75, 1992 (code for Protection of Electronic Computer/Data Processing Equipment). For
electrical power ratings on options, refer to the product rating label or the user documentation supplied with that option.
WARNING: To reduce the risk of personal injury, fire, or damage to the equipment, do not overload the AC supply
WARNING:
branch circuit that provides power to the rack. Consult the electrical authority having jurisdiction over wiring and
installation requirements of your facility.
CAUTION: Protect the server from power fluctuations and temporary interruptions with a regulating uninterruptible
CAUTION:
power supply. This device protects the hardware from damage caused by power surges and voltage spikes and keeps
the system in operation during a power failure.
Electrical grounding requirements
Electrical grounding requirements
The server must be grounded properly for proper operation and safety. In the United States, you must install the equipment in
accordance with NFPA 70, National Electric Code Article 250, as well as any local and regional building codes. In Canada, you must
install the equipment in accordance with Canadian Standards Association, CSA C22.1, Canadian Electrical Code. In all other countries,
you must install the equipment in accordance with any regional or national electrical wiring codes, such as the International
Electrotechnical Commission (IEC) Code 364, parts 1 through 7. Furthermore, you must be sure that all power distribution devices used
in the installation, such as branch wiring and receptacles, are listed or certified grounding-type devices.
Because of the high ground-leakage currents associated with multiple servers connected to the same power source, Hewlett Packard
Enterprise recommends the use of a PDU that is either permanently wired to the building's branch circuit or includes a nondetachable
cord that is wired to an industrial-style plug. NEMA locking-style plugs or those complying with IEC 60309 are considered suitable for
this purpose. Using common power outlet strips for the server is not recommended.
Rack warnings and cautions
Rack warnings and cautions
WARNING:
WARNING:
When all components are removed, the server weighs 10.40 kg (22.93 lb). When all components are installed, the server
can weigh up to 19 kg (41.89 lb).
Before configuring your rack solution, be sure to check the rack manufacturer weight limits and specifications. Failure
to do so can result in physical injury or damage to the equipment and the facility.
WARNING:
WARNING:
The server is heavy. To reduce the risk of personal injury or damage to the equipment, do the following:
Observe local occupational health and safety requirements and guidelines for manual material handling.
Get help to lift and stabilize the product during installation or removal, especially when the product is not fastened
to the rails. The server weighs more than 10.40 kg (22.93 lb), so at least two people must lift the server into the
rack together. An additional person may be required to help align the server if the server is installed higher than
chest level.
Use caution when installing the server in or removing the server from the rack.
Adequately stabilized the rack before extending a component outside the rack. Extend only one component at a
time. A rack may become unstable if more than one component is extended.
Do not stack anything on top of rail-mounted component or use it as a work surface when extended from the rack.
WARNING:
WARNING:
To reduce the risk of personal injury or damage to the equipment, be sure that:
The rack has anti-tip measures in place. Such measures include floor-bolting, anti-tip feet, ballast, or a combination
as specified by the rack manufacturer and applicable codes.
The leveling jacks (feet) are extended to the floor.
The full weight of the rack rests on the leveling jacks (feet).
The stabilizing feet are attached to the rack if it is a single-rack installation.
HPE ProLiant ML350 Gen11 Server User Guide
38
Advertisement
