HPE ProLiant ML350 Gen11 User Manual page 44

Hide thumbs Also See for ProLiant ML350 Gen11:

Remove the access panel

Remove the fan cage

Remove the primary riser cage

Remove the secondary riser cage

Remove the HPE NS204i Boot Device

Install the primary/secondary riser cage

Install the fan cage

Install the access panel

Position the tower server for operation

Install the front bezel

Install the server into the rack

Power up the server

Power down the server

Before powering down the server for any upgrade or maintenance procedures, perform a backup of critical server data and programs.

IMPORTANT:

When the server is in standby mode, auxiliary power is still being provided to the system.

To power down the server, use one of the following methods:

Press and release the Power On/Standby button.

This method activates a controlled shutdown of applications and the OS before the server enters standby mode. It can also activate

a shutdown behavior governed by an OS configuration or policy.

Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter standby mode.

This method forces the server to enter standby mode without properly exiting applications and the OS. If an application stops

responding, you can use this method to force a shutdown.

Use a virtual power button selection through iLO 6.

This method initiates a controlled remote shutdown of applications and the OS before the server enters standby mode.

Before proceeding, verify that the server is in standby mode by observing that the system power LED is amber.

Extend the server from the rack

Prerequisites

Before you perform this procedure, review the Rack warnings and cautions.

Procedure

Slide the server tray out of the rack:

1. Loosen the server tray thumbscrews (callout 1).

2. Grasp the tray notch and slide the server out of the rack (callout 2).

HPE ProLiant ML350 Gen11 Server User Guide