Advertisement
Installing the HPE NS204i Boot Device
Installing the HPE NS204i Boot Device
Installing the HPE NS204i Boot Device
Installing the
HPE NS204i Boot Device
Prerequisites
Prerequisites
Before you perform this procedures, make sure the following:
Fan 1 is installed
The server is updated with the latest operating system firmware and drivers.
Identify the HPE NS204i Boot Device components
Review the Limited operating inlet ambient temperature requirements for HPE NS204i Boot Device for a specific system
operating temperature requirement.
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
Phillips No. 1 screwdriver
Procedure
Procedure
Installing drives onto the boot device
Installing drives onto the
boot device
1. Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callouts 2).
c. Slide the carrier out from the boot device cage (callout 3).
2. Install the SSDs on the boot device carrier:
a. Remove the SSD mounting screw.
HPE ProLiant ML350 Gen11 Server User Guide
134
Advertisement
