Removing And Installing Sunlight Penetration Photosensor -G107 - Audi A3 1997 Manual

Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000
=> Inner Body Assembly; Repair group 68
- Remove bolt clip for foam cover.
- -> Fold foam cover -A- to one side.
- Remove screws -B- and take off cover -C-.
- -> Disconnect connector -A- from fresh air blower.
- Pull fresh-air blower -B- downwards out of air conditioner.
Detaching fresh air blower -V2 from base plate
- -> Remove bolt -A-.
- Pull fresh air blower out of base plate -B-.
Notes:
◆ A soundproofing mat can be attached to base plate -B- for noise insulation.
◆ When installing the fresh air blower in the base plate, ensure that connectors -C- are correctly positioned.
◆ Following installation, ensure that the fresh air blower is properly positioned in the air conditioner.

6.7 - Removing and installing sunlight penetration photosensor -G107

180
87 - Air conditioning
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.