Audi A3 1997 Manual page 125

=> Relevant Workshop Manual Engine; Mechanical Components; Repair group 19
- -> Fold up pre-punched points -A- of the thermal insulation mat and remove the hexagon nuts located behind
with washer -B- (tightening torque 15 Nm).
- Remove hexagon nuts with washer -C-.
Note:
A fitting must accompany the seal at the hexagon nut washers.
- -> Place a container under connection -B- and carefully blow out the refrigerant from the heat exchanger (in
flow direction of refrigerant using compressed air) via connection -A- (different types, observe flow direction
of refrigerant).
- Remove glove compartment.
=> Inner Body Assembly; Repair group 68
- Remove driver's storage compartment, centre console and dash panel fascia.
=> Inner Body Assembly; Repair group 70
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
- -> Remove air duct -A- to defroster vent.
- Remove footwell vent =>Page
Heating, Air Conditioner - Edition 06.2000
112 .
Audi A3 1997 ➤
3.1 - Removing and installing heater
119