Audi A3 1997 Manual page 155

-> Fig.4 Installing pulley
- Clean the contact surface.
- Install the pulley with the special tool V.A.G 1719/2 and a plastic-headed hammer.
-> Fig.5 Installing solenoid
- Place the lug -A- in the recess.
-> Fig.6 Checking gap width
- Check the gap width between the pulley and clutch plate:
- Gap width = 0.3 - 0.6 mm
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Heating, Air Conditioner - Edition 06.2000
Audi A3 1997 ➤
149
4.3 - "Zexel" compressor