Removing And Installing Positioning Motor For Fresh/Recirculated Air Flap -V154 - Audi A3 1997 Manual

- Remove bolt clip for foam cover.
- Fold foam cover -C- to one side.
- -> Disconnect connector -A- from series resistor.
- Remove screws -B- and remove resistor holder.
Removing the series resistor from its holder
- -> Drill off or detach securing elements -A-.
- Push back catches -C-.
- Remove series resistor -B-.
Note:
When installing, fasten series resistor with self-tapping screw -D- 3.2 x 10 mm.

1.18 - Removing and installing positioning motor for fresh/recirculated air flap -V154

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
- Remove glove compartment.
=> Inner Body Assembly; Repair group 68
- -> Detach connector -A-.
- Remove bolt -B-.
- Remove positioning motor in direction of arrow.
Installation notes:
◆ When inserting the positioning motor, ensure that the bracket -D- is correctly positioned in slot -E-.
Heating, Air Conditioner - Edition 06.2000
1.17 - Removing and installing series resistor -N24 for fresh air blower
Audi A3 1997 ➤
109