Audi A3 1997 Manual page 31

Initiate basic setting
Enter display number XXX
- Enter display group number 01 or 001 (depending on the software version installed in the fault reader).
- Press Q to confirm entry.
Note:
◆ The following positioning motors are now actuated one after the other and their end stop positions are stored
in operating and display unit -E87 (resistance of the potentiometers fitted in the positioning motors):
- Temperature flap positioning motor -V68.
- Central flap positioning motor -V70
- Footwell/defroster flap positioning motor -V85.
- Air flow flap positioning motor -V71.
-> Indicated on display:
Basic setting 1
XXX XXX XXX
Note:
It is possible to track the movement of the positioning motors on the display (feedback values change).
-> Indicated on display:
Basic setting 1
0 0 0
When 0 appears on the display, basic setting has been completed.
- Press the ⇒ key.
-> Indicated on display (function selection):
Rapid data transfer
Select function XX
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
- Press keys 0 and 2. (02 selects the "Interrogating fault memory" function.)
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
-> Indicated on display:
Rapid data transfer
02 - Interrogate fault memory
- Press Q to confirm entry.
-> The number of stored faults or "No fault identified" is indicated on the display.
X faults detected
- Press ⇒key.
The stored faults are displayed and printed out one after the other.
- After the last fault has been displayed and printed out, rectify the faults in line with the fault table
(=> Page 9 ).
- Press the ⇒ key.
-> Indicated on display (function selection):
Rapid data transfer
Select function XX
HELP
XXX
0
HELP
Q
HELP
Heating, Air Conditioner - Edition 06.2000
Audi A3 1997 ➤
6.1 - Basic setting
25