Audi A3 1997 Manual page 241

Fig.1 -> Assembling housing
- Screw together the two halves of the housing at points -B- with suitable bolts -A-.
Fig.2 -> Attaching seal to evaporator refrigerant lines
- Seal refrigerant lines -C- to the two halves of housing -B- with seal -A-.
- After assembling both halves of the housing, seal off refrigerant line outlet area with silicone rubber.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Fig.3 -> Attaching seal to evaporator
- Seal top and both sides of evaporator -A- to housing with seal -B-.
Note:
The underside of the evaporator must not be sealed (so that condensation water can drain off).
Heating, Air Conditioner - Edition 06.2000
13.4 - Dismantling and assembling air conditioner
Audi A3 1997 ➤
235