Remove And Install High-Pressure Sensor -G65; O-Ring Seals For Refrigerant Circuit - Audi A3 1997 Manual

3.3 - Remove and install High-pressure sensor -G65

- -> Detach connector.
- Remove High-pressure sensor -B-
Tightening torque: 5 Nm
- Replace O-ring seal -A- (10.8 mm; 1.8 mm) =>Page
Notes:
◆ The refrigeration capacity cannot be checked if sender -G65 is removed - control unit -J293 does not switch
on the compressor.
◆ The refrigerant circuit remains closed - connection with valve.
◆ Check function of high-pressure sensor -G65 and signal emitted =>Page

3.4 - O-ring seals for refrigerant circuit

◆ Only use once and then replace.
◆ Moisten with refrigerant oil before use.
◆ Ensure that they are positioned correctly on the pipe or in the groove.
◆ Take care to avoid dirt.
Notes:
◆ -> Only install O-ring seals which are resistant to refrigerant R134a and the associated refrigerant oil. These
O-ring seals are colour-coded to prevent confusion (currently "red", "lilac" or "violet"):
=> Parts List
◆ In addition to the coloured O-ring seals, black O-rings are also used in production for certain connections.
◆ Dimensions -a- and -b- vary depending on the fitting location of the O-ring seal.
=> Parts List
Heating, Air Conditioner - Edition 06.2000
137
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A3 1997 ➤
.
85 .
3.3 - Remove and install High-pressure sensor -G65
137