Removing And Installing Dash Panel Temperature Sensor Blower -V42 - Audi A3 1997 Manual

Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000

6.13 - Removing and installing dash panel temperature sensor blower -V42

In vehicles with an operating and display unit -E87 with two displays
- Remove glove compartment.
=> Inner Body Assembly; Repair group 68
- -> Remove 2 bolts -A-.
- Detach connector -C-.
- Detach suction hose -B- and remove blower in direction of arrow.
Notes:
◆ Check function =>Page
◆ Check suction hose -B-. It must not be sealed and must be firmly attached to the temperature sensor con‐
nection piece.
In vehicles with an operating and display unit -E87 with one display
- Remove operating and display unit -E87 => Page
- -> Remove bolts -A-.
- Remove Blower -V42 -B- from -E87.
Note:
Do not press motor -C- when installing blower -V42 but hold the blower at the housing.
184
87 - Air conditioning
18 (final control diagnosis).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
177 .