Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000
1.16 - Removing and installing fresh air blower -V2
-
Remove glove compartment.
=> Inner Body Assembly; Repair group 68
-
Remove series resistor -N24 => Page
-
-> Disconnect connector -A- from fresh air blower.
-
Pull fresh air blower -B- downwards out of heater.
Detaching fresh air blower -V2 from base plate
-
-> Remove bolt -A-.
-
Pull fresh air blower out of base plate -B-.
Notes:
◆ A soundproofing mat can be attached to base plate -B- for noise insulation.
◆ When installing the fresh air blower in the base plate, ensure that connectors -C- are correctly positioned.
◆ Following installation, ensure that the fresh air blower is properly positioned in the heater.
1.17 - Removing and installing series resistor -N24 for fresh air blower
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
108
80 - Heating
109
.