Audi A3 1997 Manual page 183

◆ When installing bolts -A-, insert the bracket for trim -B- on the correct side.
- -> Press back catches on connector and detach connector.
Removing and installing the operating and control unit -E87 with only one display
Removing
- Remove radio or radio navigation system:
=> Radio, telephone, navigation; Repair group 91; Navigation System Navigation System
- Reach through the opening and push the operating and display unit back
Notes:
◆ -> The operating and display unit is secured with 4 retaining clips -A- in the centre console.
◆ When replacing an operating and display unit, note the precise layout (e.g. with or without breakthrough for
the heated seat switches)
=> Parts List
◆ To remove the switches for the heated seats, press back the lugs -B- and pull the switch -C- back out of the
operating and display unit.
◆ If the dash panel temperature sensor -G56 produces a faulty measurement, check the intake grille on the
trim panel - must not be closed.
◆ -> In this type of the operating and display unit the connector -A- is no longer occupied.
◆ The heated rear window is activated via the connector -F-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Heating, Air Conditioner - Edition 06.2000
6.2 - Removing and installing operating and display unit -E87
Audi A3 1997 ➤
177