Check Signal From High-Pressure Sensor -G65 - Audi A3 1997 Manual

Note:
The pump for refrigerant run-out -V51 is only present in certain engine variations.
=> Current Flow Diagrams, Electrical Fault-Finding and Fitting Locations
=> Relevant Workshop Manual Injection and Ignition system

11.4 - Check signal from high-pressure sensor -G65

-> A- Pressure on high-pressure side of refrigerant circuit in bar (overpressure)
B- Duty cycle of the square-wave signal
C- Curve
Notes:
◆ Control unit -J293 transmits a positive signal to operating and display unit -E87:
- When duty cycle is larger than 13% (equivalent to approx. 1.2 bar overpressure) and less than 78%
(equivalent to approx. 32 bar overpressure).
- If the duty cycle is less than 13% or greater than 78%, no positive signal is transmitted to -E87, and -E87
transmits no signal to -J293 - as a result -J293 does not switch on the compressor (via magnetic clutch
-N25).
◆ If the refrigerant circuit pressure was greater than 32 bar (duty cycle greater than 78%), control unit -J293
does not re-transmits a positive signal to -E87 until the pressure drops below 24 bar (duty cycle less than
65%).
Heating, Air Conditioner - Edition 06.2000
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
11.3 - Electrical check at control unit -J293 (version for High-pressure sensor -G65)
Audi A3 1997 ➤
85