Electrical Check At Control Unit -J293 (Version For Pressure Switch -F129) - Audi A3 1997 Manual

Operating and display unit -E87 is installed.
-> Connector -A- and -B- are disconnected from control unit -J293 (the illustration shows the type which is
installed into vehicles with pressure switch -F129).

11.2 - Electrical check at control unit -J293 (version for pressure switch -F129)

-> Pin assignment for radiator fan control unit -J293 (version with pressure switch -F129)
• Location:
on left longitudinal member in engine compartment
• Function:
- Switches radiator fans -V7 to 1st and 2nd speed
- Actuates AC magnetic clutch -N25.
Notes:
Radiator fan control unit -J293 versions and vehicle wiring differ for vehicles with pressure switch -F129 and
high-pressure sensor -G65.
=> Parts List
=> Current Flow Diagrams, Electrical Fault-Finding and Fitting Locations
◆ The radiator fan -V7 is automatically switched on together with the magnetic clutch if this control unit is used.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Heating, Air Conditioner - Edition 06.2000
11.1 - Perform electrical check at radiator fan control unit -J293
Audi A3 1997 ➤
71