Figure 3-4 Pwr Connector; Figure 3-5 Xdcr Connector; Table 3-1 Pwr Connector Pinouts; Table 3-2 Xdcr Connector Pinouts - Teledyne BENTHOS UDB-9000 User Manual

3-6
To connect the deck box:
1. Connect the AC power source to the PWR connector using the AC
power cable. For reference, refer to Figure 3-4 for the connector pin
orientation, and to Table 3-1 for the pinout information.
Figure 3-4 PWR
2. Connect the transducer cable to the transducer and to the XDCR
connector on the UDB-9000. For reference, refer to Figure 3-5 for the
connector pin orientation, and to Table 3-2 for the pinout information.
Figure 3-5 XDCR
User's Manual
Connector
Connector
TELEDYNE BENTHOS
Table 3-1 PWR Connector
Pinouts
PIN DESCRIPTION
A AC Line
B AC Neutral
C AC Ground
D NC
E NC
Table 3-2 XDCR Connector
Pinouts
PIN DESCRIPTION
A Receive Return
B Receive
C Receive Shield Ground
D -15VDC
E +15VDC
F Power Ground
G Jumper 12V Bus
H Jumper Remote Power Enable
J Transducer Shield
K Transmit
L Chassis Ground
M Transmit Return
P/N M-270-10, Rev. B