Table of Contents
Advertisement
UDB-9000 Universal Deck Box - UDB-9000-M (Portable) and UDB-9000-MR (Rack Mount) Configurations
Adjusting the Touch Screen Display
Backlight and Contrast
The touch screen display backlight and contrast can be adjusted to account
for room lighting and viewing angle.
To adjust the touch screen display backlight and contrast:
1. Touch the Display function button.
The Display screen opens as
shown in Figure 4-13.
2. Touch and drag the Backlight
slider up to increase the backlight
intensity or down to decrease the
intensity. Or touch anywhere in the
slide to move the slide to that
location.
3. Touch and drag the Contrast slider
up to increase the contrast or
down to decrease the contrast. Or touch anywhere in the slide to move
the slide to that location.
4. Touch Exit to close the Display screen.
Configuring the Power Saver
The UDB-9000 includes a power saver which dims the backlight and turns off
the displays after a predetermined time, or just dims the backlight, depending
on the selection. There are two screen modes, Normal and Save:
Normal mode. The power saver is off. The touch screen backlight is on,
and the screens in the touch screen display are visible at all times.
Save mode. The power saver is on. The touch screen display backlight
will dim in one minute if the screen is not touched and then turn on again
when it is touched. Similarly, if the screen is not touched for a
predetermined time, the displays will no longer be visible, but every ten
seconds the Teledyne Benthos logo will appear for one second to indicate
that the deck box is on. When the screen is touched, the displays will be
visible again. However, the turning off of the displays can be disabled.
Touching the screen once when the power saver is on will not activate any
of the controls.
4
Operation using the Touch Screen Display
Figure 4-13 Display Screen
4-11
General Setup
Advertisement
Table of Contents
