Table of Contents
Advertisement
6-4
4. Set the electronics
chassis on its side and
slightly loosen—but do
not remove— the
battery bracket screws,
three screws for each
bracket, as shown in
Figure 6-4.
5. Rest the bottom of the
electronics chassis over
the edge of a table, one
side of the chassis at a
time, and then remove
all six of the battery
bracket screws as
shown in Figure 6-5.
6. One at a time, slide
each battery part way
out of the electronics
chassis and disconnect
the wires from the
battery terminals as
shown in Figure 6-6.
7. Remove the battery
bracket from each
battery and install a new
battery in each bracket.
User's Manual
ELECTRONICS
CHASSIS
Figure 6-4 Loosening the Battery Bracket
Screws
Figure 6-5 Removing the Battery Bracket
Screws
TELEDYNE BENTHOS
BATTERY
BRACKET
SCREWS (6)
P/N M-270-10, Rev. B
Advertisement
Table of Contents
