Power Connector; Interconnection Cable; Interlock Connector - Teledyne CP Series User Manual

User Manual
CP Series
Version 3.1 – June 2020
3.3.3 P
OWER CONNECTOR
Power is supplied through the 3 pin Cannon connector on the left side of
the PowerBox.
Thanks to the use of a Power Factor Controller (PFC), the power factor of
the PowerBox is close to 1. This will allow the PowerBox to be run from
almost any petrol or diesel power generator without suffering from interference from voltage or frequency
fluctuations.
The recommended minimum power rating of the power generator is 2kVA.
It is possible to power the CP SERIES generator set from a car or truck battery when an appropriate
12/24Vdc to 230Vac adaptor is used. The current consumption on 24V will be approximately 60A.
3.3.4 I
NTERCONNECTION CABLE
The interconnection cable connects the PowerBox to the CP SERIES generator, providing power and
communication between them.
3.3.5

INTERLOCK CONNECTOR

The interlock connector provides an interface to connect up to 5 programmable input contacts, 4
programmable output contacts for use with a 24Vdc provided by the PowerBox and 4 programmable relays
contacts. These interface contacts can be used for safety interlock systems such as door controls and audio
visible warning systems such as sirens and warning lights but can also serve as inputs for a trigger system
when integrating the X-ray into for instance cabinet systems.
The behavior of each output - when the output should be flashing, On or Off - can be programmed for each
state (stand by, pre-warning, X-ray ON) via the PowerBox menu. Please refer to the PowerBox's 'Configure
Interlock' chapter for more information on how to configure the behavior of the outputs.
26