Configuring And Checking A Remote Modem; Selecting The Remote Modem Address; Figure 4-30 Burn Wire Activated-Smart Modem; Figure 4-31 Modem Config Screen - Teledyne BENTHOS UDB-9000 User Manual

UDB-9000 Universal Deck Box - UDB-9000-M (Portable) and UDB-9000-MR (Rack Mount) Configurations
For a SMART modem, if the correct
release code was received, the
message "Burn wire ACTIVATED,"
should be displayed in the Benthos
Smart Release/Modem pop-up as
shown in Figure 4-30. Once the
burn wire has fully burned, which
may take several minutes, an alert
window opens. Touch the X mark to
close the window and the message
"Burn wire RELEASED" should be
displayed in the pop-up.
If desired, after sending the release
command, ranges can be acquired and displayed by touching Get
Range. Refer to "Acquiring and Displaying the Range to a Remote
Modem" on page 4-18 for detailed instructions.

Configuring and Checking a Remote Modem

If desired, the acoustic baud rate and the transmit power level of a remote
modem can be configured and checked. The modem firmware version can
also be checked. Although only one modem can be configured at a time, the
configuration can be prepared prior to updating for up to three modems,
designated Remote A, Remote B and Remote C. However, before a remote
modem can be configured, its address must be selected. Before sending
commands, always ensure that the transducer is connected.
Selecting the Remote
Modem Address
To select the address of the remote
modem to be configured:
1. Touch the Modem Config function
button, or touch the Modem
Address control on the Status and
Control bar. Refer to "Status and
Control Bar" on page 4-5 for a
description of this bar.
The Modem Config screen opens.
4
Operation using the Touch Screen Display
Figure 4-30 Burn Wire
Activated—SMART Modem
Figure 4-31 Modem Config
Screen
Configuring and Checking a Remote Modem
4-23