Table of Contents
Advertisement
4-22
The keypad closes and the release code is displayed as the Release
Code or Burn Wire Code setting.
WARNING Before proceeding with the next step, verify that the release
code is correct.
5. Touch—and hold—Send.
Three short beeps followed by a long beep will be heard, and then the
Send button will become highlighted.
NOTE The command will be sent only after the Send button is released. To
abort the command, continue to maintain contact with the touch screen
display while sliding the finger completely off the Send button. The Send
button will become unhighlighted. If the command successfully aborts, a
pop-up will appear with the message "Transmission Aborted."
6. Release Send.
The release command is sent and an information window temporarily
opens with the message "Valid release code, waiting for confirmation..."
for a SMART release, or "Valid burn wire code, burn started..." for a
SMART modem. If the release code is incorrect, the message "Invalid
Release Code" will be displayed, instead.
For a SMART release, if the correct
release code was received, the
message "Released
CONFIRMED," should be
displayed in the Benthos Smart
Release/Modem pop-up as shown
in Figure 4-29. This message
acknowledges that the release
mechanism has been activated
and that the release has released
itself from its mooring. If instead,
the message "Released &
unconfirmed" is displayed, the
release mechanism has been
activated but the release has not released itself from its mooring.
User's Manual
TELEDYNE BENTHOS
Figure 4-29 Released
CONFIRMED—SMART Release
P/N M-270-10, Rev. B
Advertisement
Table of Contents
