Table of Contents
Advertisement
UDB-9000 Universal Deck Box - UDB-9000-M (Portable) and UDB-9000-MR (Rack Mount) Configurations
Calibrating the Touch Screen Display
If when touching a control, it does not respond, the touch screen display may
require calibration.
To calibrate the touch screen display:
NOTE If the UDB-9000 is currently turned off, touch and hold in the lower
right corner of the screen while turning the deck box on. This method will
open the calibration screen immediately.
1. Touch the Display function button.
The Display screen opens as
shown in Figure 6-9.
2. Touch Calibrate Screen.
The Confirm Screen Calibration
pop-up opens as shown in
Figure 6-10.
If any settings were changed, they
will be lost after the screen
calibration is complete. To save the
settings, touch Cancel, touch the
Save function button, and then
repeat these two steps.
3. Touch OK.
4. Follow the instructions to touch each of the displayed crosses.
The UDB-9000 restarts and the opening screen is displayed as shown in
Figure 4-1 on page 4-1.
6
Care and Maintenance
Figure 6-9 Display Screen
Figure 6-10 Confirm Screen
Calibration Pop-Up
Calibrating the Touch Screen Display
6-7
Advertisement
Table of Contents
