Intel 852GME Design Manual page 73

R
the signal should transition to an external layer and connect to the appropriate pad of the connector.
After the SO-DIMM0 transition, continue to route the signal on the same internal layer to SO-DIMM1.
Transition back out to an external layer and connect to the appropriate pad of SO-DIMM1. Connection
to the termination resistor should be via the same internal layer with a transition back to the external
layer near the resistor. External trace lengths should be minimized.
To facilitate routing, swapping of the byte lanes is allowed for SDQ[63:0] only. Bit swapping within the
byte lane is also allowed for SDQ[63:0] only. The check bits, SDQ[71:64], cannot be byte lane swapped
with another SDQ byte lane. Also, bit swapping within the SDQ[71:64] byte lane is not allowed. It is
suggested that the parallel termination be placed on both sides of SO-DIMM1 to simplify routing and
minimize trace lengths. All internal and external signals should be ground referenced to keep the path of
the return current continuous.
Resistor packs are acceptable for the series (Rs) and parallel (Rt) data and strobe termination resistors,
but data and strobe signals can't be placed within the same R pack as the command or control signals.
The table and diagrams below depict the recommended topology and layout routing guidelines for the
DDR-SDRAM data signals.
Intel recommends that the full data bus SDQ[71:0], mask bus SDM[8:0], and strobe signals SDQS[8:0]
be routed on the same internal signal layer. It is required that the SDQ byte group and the associated
SDM and SDQS signals within a byte lane be routed on the same internal layer.
The total length of SDQ, SDM, and SDQS traces between the GMCH/MCH and the SO-DIMMs must
be within the range defined in the overall guidelines, and is also constrained by a length range boundary
based on SCK/SCK# clock length, and a SDQ/SDM to SDQS length matching requirement within each
byte lane. Note also that all length matching must be done inclusive of package length. A table of SDQ,
SDM, and SDQS package lengths is provided at the end of this Section to facilitate this process.
There are two levels of matching implemented on the data bus signals.
The first is the length range constraint on the SDQS signals based on clock reference length.
The second is SDQ/SDM to SDQS length matching within a byte lane.
The length of the SDQS signal for each byte lane must fall within a range determined by the clock
reference length, as defined in the SDQS to SCK/SCK length matching section. The actual length of
SDQS for each byte lane may fall anywhere within this range based on placement and routing flow.
Once the SDQS length for a byte lane is established, the SDQ and SDM signals within the byte lane
must be length matched to each other, inclusive of package length, as described in the SDQ to SDQS
length matching Section 6.3.2.3.
® ®
Intel 852GME, Intel 852GMV and Intel
System Memory Design Guidelines (DDR-SDRAM)
®
852PM Chipset Platforms Design Guide
73