Table of Contents
Advertisement
Configuration of analog Devices
7
If you pick up the receiver telephone after having plugged in a new tel-
ephone, please dial
and hang up. Thanks to this the PBX will learn
the dialling mode.
If the new telephone has a dual-tone multifrequency dialling, check
whether the FLASH key was activated and configure the FLASH period
as short as possible (see operation instruction of the telephone). Then
you execute the programming described in the following. Subsequent to
this the PBX has learned the exact duration of the FLASH time of your
telephone. This is very important e.g. for the Transfer or Query. Analog
telephones that execute certain function via T-Net function key/menu
are using a long FLASH (300 ms). Often an additional FLASH key is
available. Configure this also to 300 ms and execute the following pro-
gramming again.
Learn Flash Duration
b 7 Q 55 FF #
your DTMF
public
telephone
pass-
word
Configuration of ISDN Devices
You must inform each Auerswald system telephone and each ISDN
device (Euro-ISDN telephones, ISDN FAX machines, ISDN PC-control-
lers etc.), about the internal telephone number it has to react on. For this
purpose you enter the telephone numbers (for example 29; see picture
on
page
37) as 1st MSN into the device. How this does work can be
learned in the operation manuals of the corresponding devices.
Due to the free telephone numbering plan it is only clear after having fin-
ished the configuration which internal telephone number is available for
the corresponding internal S
port. If you like to enter telephone num-
0
bers into a couple of telephone numbers nevertheless in order to make
internal test calls before starting the configuration, simply use the inter-
nal telephone numbering plan that will be there after the first operation
or that you can create by pressing a button later. (see
an internal Telephone Numbering Plan by pressing a Button on
page
16).
Please use each of these telephone numbers once. If one of these
numbers is assigned twice, a proper functionality can not be guaranteed
anymore.
Besides this make sure that this 1st MSN of the corresponding device
is also presented to the PBX.
Normally an ISDN subscriber is fixed to the internal S
was configured for. But if you activate in the configuration program that
the ISDN subscribers may move from port to port, all the ISDN devices
will be allowed to be connected to any other internal S
COMmander Basic recognizes the subscriber again and registers him
to the other port if the receiver is picked up for a short moment after
plugging into another ISDN wall jack. Also in this case the maximum
quantity of ISDN devices on one internal S
(a maximum of 8 ISDN devices, but a maximum of four bus-powered
devices).
Automatic PBX Software Update
If you like to make sure that the COMmander Basic has the most current
operation software, you can execute an automatic PBX software update
now (see
chapter The Automatic PBX Software Update Button on
page
16).
Final Steps
press the FLASH key
twice
chapter Creating
port which he
0
port. The
0
port must not be exceeded
0
Close the Case
If you finished the installation and put the cable properly in the cable
space, (the installation chassis offers fixing hooks), you can close the
cover. Put the case cover on the chassis as shown in
shove the cover down vertically until it clicks into its correct position.
Pic. 49: Installation finished
Pic. 50: Close the Case
39
Commissioning
Pic.
50. Then you
Advertisement
Table of Contents
