Table of Contents
Advertisement
60
Remote Programming
Remote Programming without manual Authorization
If you like to do remote programming without manual authorization by
the customer, you have to pre-configure the customer's PBX.
Under „Passwords" in the configuration program of the PBX the Dealer
MSN must be entered. If your ISDN PC-controller for the remote pro-
gramming is directly connected to the external NT, use the main tele-
phone number (with area code) of your ISDN connection.
The data accessed by the programs COMtools, COMlist and Soft-LCR
easy can be protected by the user password.
For the read-out of call data with COMlist the user password
is mandatory.
On the page „Remote programming" select an otherwise unused tele-
phone number of the customer as a remote switching and program-
ming MSN. Besides this configure the remote switching response time
to 10 seconds or less.
Enter a administrator password to protect the configuration.
Process of the Remote Programming:
Open the configuration program of the PBX and select the interface
ISDN PC-controller (CAPI 2.0) in the menu under „options...interface".
If you save an open file into the customer's PBX click on the button
„Save". If you like to read the data out of the PBX click on the button
„Open". Select then „remote config.".
Enter the administrator password of the customer's PBX and click on
„OK".
(For remote access with COMtools and COMlist the entry of the user
password is mandatory.)
Here you enter the remote switching and programming MSN of the
customer's PBX. Then you confirm the dialog by clicking „OK".
Exchange Line Access Number 0 for ISDN PC-controller on internal
S
port (if not configured as Direct Exchange Line Telephone)
0
Advertisement
Table of Contents
