Table of Contents
Advertisement
The Door Module: Description and Connection
Description of the COMmander 2TSM analog Module (not enclosed)
The COMmander 2TSM analog module does not belong to the basic
unit of the COMmander Basic. It is an analog door -/switch -/music -
module. The COMmander Basic can be extended with a maximum of
one COMmander 2TSM analog module.
Thanks to the COMmander 2TSM analog module you can connect or
control two door terminals, each consists of a door handsfree system, a
door opener and two door bell buttons. Herewith the door ringing to all
The Door Module: Description and Connection
internal subscribers will be possible as well as the door conversation
and door opening. And it is possible to connect an external ringer (sec-
ond ringer bell) for additional signalization.
In order to execute different switching and controlling processes, the
module has a total of six relays that have to be configured correspond-
ingly to the special purpose. Four of these relays are pre-configured for
controlling both door terminals. If no door terminals are to be controlled,
these relays can be reconfigured for other uses.
Pic. 34: Analog door-/switch-/music-module
Clamps (detachable) for connecting door terminal 1:
– In/Output of NF voltage against TGND (labelled as
TNF1).
– Make contact of relay no. 1 for supplying the door hands-
free system (labelled as TS11, TS12).
– Make contact of relay no. 2 for supplying the door opener
(labelled as TO11, TO12).
– Inputs for connecting the door bell buttons 1 and 2 (also
usable as alarm contact, labelled as KLIN1, KLIN2).
3-pole plug, the middle pin has 12 V for the use on door
terminal 1.
Clamps (detachable) for connecting door terminal 2:
– In/Output of NF voltage against TGND (labelled as
TNF2).
– Make contact of relay no. 3 for supplying the door hands-
free system (labelled as TS21, TS22).
– Make contact of relay no. 4 for supplying the door opener
(labelled as TO21, TO22).
– Inputs for connecting the door bell buttons 3 and 4 (also
usable as alarm contact, labelled as KLIN3, KLIN4).
3-pole plug, the middle pin has 12 V for the use on door ter-
minal 2.
Clamps (detachable):
– Output of the 12 Volt operation voltage.
– Output for connecting a second ringer bell.
– Make contact of relay no. 6.
– Make/Break contact of relay no. 3.
Cinch connector (mono) for connecting a music output
device for feeding in external Music on Hold.
Trimmer for volume setting of recorded external Music on
Hold.
LEDs for indicating the on/off mode of the relay.
Plug for attachment to the mainboard.
Cinch connector (announcement output) for connecting a
loudspeaker.
Jack for the connection to a front plate of the 19" version.
27
Advertisement
Table of Contents
