Auerswald ISDN Installation And Configuration Manual page 24

24
Connection to the NT
corresponding S port. Connect this with the clamps of the NT. Advice
0
on the preferred cable types can be found in the
additional ISDN Wall Jacks on page
ISDN
IIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIII
chapter Installation of
20.
ISDN
IIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIII
Pic. 28: Direct connection to the NT (PTMP connection)
Pic. 29: Connection to the external S
If there are further passive devices directly connected to the
NT in parallel to the COMmander Basic and if the NT is
equipped with a 230 Volt power supply, it must be plugged in.
If the COMmander Basic only is operated directly on the NT, you may
leave the NT unpowered in order to save energy.
ON
1 2
bus (PTMP connection)
0