Table of Contents
Advertisement
Operation
Action
Warm reset
Cold reset
Original reset
x = Value is retained, - = Value is re-initialised
9.2.2
Cold start, "Startup"
A reset via the "Power Off" operating status performs a system cold start with "Startup".
}
Switch the 24 VDC supply voltage to the motion controller off and then on again.
}
The motion controller changes to "Startup" operating status.
9.2.3
Reset commands
9.2.3.1
Warm reset
This command
}
Stops the user program.
}
Resets all variables to the value with which they were initialised (exception: variable with
attribute RETAIN).
}
Resets all variables that have not been explicitly initialised to a default initialisation value.
Commands:
}
Command language: RS4
}
IEC 61131 programming: Menu Online -> Reset
9.2.3.2
Cold reset
This command
}
Stops the user program.
}
Resets all variables to the value with which they were initialised.
Commands:
}
Command language: RS5
}
IEC 61131 programming: Menu Online -> Reset (cold)
9.2.3.3
Original Reset
This command
}
Deletes the user program.
}
Resets all variables to the value with which they were initialised (including remanent vari-
ables with attribute RETAIN and PERSISTENT).
}
Resets the motion controller to its original condition (factory defeault settings).
Operating Manual PMCprimo C2
1004683-EN-02
Variable with attrib-
ute RETAIN
x
-
-
Variable with attrib-
Variable with attrib-
ute PERSISTENT
ute
RETAIN PERSIST-
ENT
-
x
-
-
-
-
| 61
Advertisement
Table of Contents
