Table of Contents
Advertisement
Function description
}
Hardware reset (cold start): Change from operating states "RUN" or "STOP" to "Star-
tup" (if a USB stick is inserted, any device data present will be copied, see
the reset button [
}
Change from "RUN" operating status to "STOP"
}
Change from "STOP" operating status to "RUN"
5.2
Software
5.2.1
Software PMCprimo C2
Various tools are available for planning, configuration, programming and commissioning.
They are used to create a project:
}
PASmotion
PASmotion is used to parameterise and commission the motion controller.
– Terminal program: The terminal can be used to transfer commands directly to the
– Oscilloscope function: PScope is a PC-based oscilloscope with up to 4 channels. It
– Elliptical curve tool: PMotion is a tool for constructing elliptical curves.
}
Development environment in accordance with IEC 61131-3
CODESYS is a development environment for programming controllers in accordance with
IEC 61131-3. Additional commands for motion sequences have been added. In addition
to the core CODESYS packages the "PMC Programming Tool" also contains the target
support packages and the PMCprimo base project.
}
DriveControlSuite
DriveControlSuite is used to set parameters and commission the drive controller PMC
SC6/PMC SI6.
The software tools are available on the Internet at www.pilz.com.
Operating Manual PMCprimo C2
1004683-EN-02
62].)
INFORMATION
For further information on the reset button see the chapter entitled
Operation [
hardware. It can also be used for firmware updates and for basic configuration of the
motion controller.
can be used to record and visualise signals from controllers.
56].
Functions of
| 26
Advertisement
Table of Contents
