Table of Contents
Advertisement
Commissioning
12:
16
22:
23:
24:
26:
27:
28:
29:
34:
35:
36:
Choice [Return; ESC exits menu]:
Once you exit the menu the basic configuration is active and saved, if changes have been
made. It may be necessary to reboot the motion control system for the changes to take ef-
fect.
8.2.7
Operate PMCprimo C2
You can operate the motion controller in the commissioning software terminal by issuing
commands in the command language.
HW1 - Show Hardware
0.1: hw1
0.1:
SOFTWARE
Firmware:
Motion:
IEC PLC:
Interpolation: INSTALLED
ETHERNET
IP address
Netmask
Gateway
CHANNELS
Number
HARDWARE
Type:
Operating Manual PMCprimo C2
1004683-EN-02
Change number of channels
Change startup delay
Enable slave mode for CAN
Set CAN2 cycle time
Change cycle time of system
Set address for PMCprotego with SD-Card
Change channel for encoder
Set number of ModbusClient
Change ModbusClient Parameter
Activate PROFIBUS/CAN
Set Codesys Version
Reserve CAN for Codesys
03.06.00, Dec 16 2020, 13:20:52
INSTALLED
INSTALLED
192.168.0.11
255.255.255.0
192.168.0.1
1...32
PMCprimo C2 1.3 GHz CAN/CAN
| 53
Advertisement
Table of Contents
