Introduction; Validity Of The Documentation; Retaining The Documentation; Definition Of Symbols - Pilz PMCprimo C2 Operating Manual

Introduction

1 Introduction
1.1

Validity of the documentation

This documentation is valid for the product PMCprimo C2. It is valid until new documenta-
tion is published.
This operating manual explains the function and operation, describes the installation and
provides guidelines on how to connect the product PMCprimo C2.
Please refer to the following documents from the Motion Control range:
}
The online help for the PASmotion commissioning software describes how to set the
parameters for the servo amplifiers from the PMC product area.
}
The online help for the DriveControlSuite commissioning software describes how to set
the parameters for the drive controllers from the PMC product area.
}
Guidelines regarding installation and environmental conditions can be found in the oper-
ating manual for the servo amplifier PMCprotego D.
}
Guidelines regarding the handling and the environmental conditions can be found in the
operating manual of the drive controller PMC SC6/PMC SI6.
}
The configuration and programming software for motion control devices (e.g. CODESYS,
PASmotion) can be found on the Internet.
You can find all the documents in the Internet at www.pilz.com.
You will need to be conversant with the information in these documents in order to fully un-
derstand this operating manual.
1.1.1

Retaining the documentation

This documentation is intended for instruction and should be retained for future reference.
1.2

Definition of symbols

Information that is particularly important is identified as follows:
Operating Manual PMCprimo C2
1004683-EN-02
DANGER!
This warning must be heeded! It warns of a hazardous situation that poses
an immediate threat of serious injury and death and indicates preventive
measures that can be taken.
WARNING!
This warning must be heeded! It warns of a hazardous situation that could
lead to serious injury and death and indicates preventive measures that can
be taken.
| 6