Table of Contents
Advertisement
Commissioning
8.2.3
Establish communication between PMCprimo C2 and PC
The following steps describe how to establish a connection between the PC and motion
controller via the Ethernet interface.
Prerequisite:
}
The commissioning software PASmotion is installed on the PC.
}
The supply voltages (24 V DC) are present on PMCprimo C2.
}
The configuration PC is connected to the Ethernet interface X43 on the PMCprimo C2.
Establish connection
1. Start the commissioning software PASmotion.
2. Select the Terminal window.
3. Click on the icon
The Connection Settings window opens.
You can now connect to a known network subscriber. If you do not know the IP address,
you can browse the network for subscribers.
Alternative 1: The IP settings are known
}
Prerequisite: The PMCprimo C2 and PC must be in the same network or be accessible
via a Router.
1. Select Ethernet.
The New Connection window opens.
2. Enter the IP address in the connection settings and select Finish.
The connection to the PMCprimo C2 is established.
Alternative 2: The IP settings are unknown
}
Prerequisite: The PMCprimo C2 and the PC are in the same broadcast domain.
1. Select Ethernet.
2. From the list, select the subscriber to which you wish to connect.
Note: Click on Ping to identify the device's hardware.
3. Select Configuration... The Device Configuration window opens.
4. Enter the IP settings and then select Use this IP address. The Connection Wizard
window opens.
5. Select Finish.
The network subscriber is connected.
Operating Manual PMCprimo C2
1004683-EN-02
- Create New Connection.
| 48
Advertisement
Table of Contents
